March 23, 2012 - 8:54am
STARTER FLOAT TEST
What does the float test have to do with the viability of the starter? I refresh my starter 1:3:3 for 12 hours then refrigerate overnight use in the morning and it does not float because most co2 has been expelled, but my breads come out wonderful.
Thanks again to everyone for there contribution to TFL
Share
I know the float test from Chad Robertson's recipes but don't pay it too much attention. If you drop a spoonful of levain into water and it floats, that indicates it has lots of CO2 and is at a good stage for mixing with your dough. If it doesn't float it might be too early, OR the CO2 may have already dissipated as is the case with yours. But assuming the CO2 was there at some point it will still make good bread, just may take a bit longer in the proofing.
I recently feed my sourdough to bring it back was in refrigerator for about 2 months in the morning the sourdough overflowed all over the place has this happened to anyone else?
Yes, I have starter overflow its vessel from time to time. I need to use a bigger vessel as it's no fun to wipe up.
I don't do a float test. When I refresh, if it's bubbly and foamy it's ready to go. That usually takes about 4 hours.