The Fresh Loaf

A Community of Amateur Bakers and Artisan Bread Enthusiasts.

Fire in the hole

neoncoyote's picture
neoncoyote

Fire in the hole

Well, it had to happen eventually. After shattering the inside pane of oven glass with water from my steaming pan several months ago, I took the next logical step and set the oven on fire. I was rotating the baguettes with a spatula, as I do after removing the steam pan, and I noticed a few sparks on the element...didn't think much of it until I gave one loaf a big turn, then the flames started. I can only figure it was cornmeal hitting the element. I should have just turned off the oven, shut the door to cut off the air supply, and kept an eye on the flames; but I panicked and turned the oven off and shot the fire extinguisher at it. While the flame was immediately quenched, needless to say, the chemical-covered bread is now in the trash. I had taken such care with this batch, too, which was to grace a friend's dinner party table. 

Anyway...my question is whether, after a thorough cleaning, I can continue to use my element; or whether, after being sprayed with fire extinguisher chemicals while it was hot, I need to replace it? Thoughts, experiences...? Thank you!

LindyD's picture
LindyD

#1 - am glad you didn't get hurt.  #2, I shouldn't admit it, but it is a funny story - now that all the excitement is over.

Here's  a link which may answer some of your questions.

To make you feel better about your experience, I had purchased a cheapo thermometer with a suction cup so I could monitor the temp of my natural gas oven when I turned the light on (it's pilotless and I sometimes use the heat from the oven light for proofing).

One day I turned on the oven to 500F to preheat it.  About ten minutes into the preheating I smelled something funny.  Yup - I had forgotten to remove that plastic thermometer, which had turned into a melted glob of plastic running down the oven wall.  

Took some elbow grease, but I did manage to remove all traces of the melted plastic gunk. 

Hope your story ends as well.

neoncoyote's picture
neoncoyote

I appreciate the commiseration and Lindy, thank you for the link...that didn't turn up on my google search. Onward with the clean-up today.

Mebake's picture
Mebake

Wow, Good you've survived it! I guess heat from the element will dissipate the chemicals.

 

reddragon's picture
reddragon

but it's really funny. Bakers have the most fun.

amauer's picture
amauer

I had a heating element fire years ago. I mistakenly unplugged what I thought was the oven and it kept going. I thought what madness is this? I had unplugged the microwave and forgot the stove outlet was on the floor behind the stove. My new one does not have a floor element. Then, a few years ago I started a burner to make pasta, but started the wrong one and melted a pan. It looked whole until I went to move it and it disintigrated and started my linoleum floor on fire. I threw the dogs water dish on it and counted my self lucky (and klutzy). Now after hearing about your glass window, I am less concerned about my "steaming the bread for the prefect crust." I know I can't afford a new one.  

hanseata's picture
hanseata

Cooks Illustrated tested fire extinguishers for kitchen fires a while ago. Basically everyone of them "created noxious fumes and messy residue", and damaged ("scarred") the surface of kitchen appliances.

Probably you should better ask a pro ( the manufacturer) whether burner elements damaged by fire extinguisher foam can emit toxic fumes.

Karin