The Fresh Loaf

News & Information for Amateur Bakers and Artisan Bread Enthusiasts

Make shift proofing box...

  • Pin It
CaptainBatard's picture
CaptainBatard

When making Pan D'oro recently I realized...it being winter in the North East and my house hovering around 62-65*(by choice)I had to come up with a better way of keeping a constant temperature for my sweet starter. I could always fall back on the old pot holder trick (3 folded pot holders=76*) in the stove door with the light on. It works in a pinch but, I always run into this problem of proofing temperature. In the summer it is too hot (I can't bake or i have to use ice water baths) and in the winter it is too cold. I've been tooling around with many ideas on how to make a proofer work... a plug-in car refrigerator/cooler or wine vault for the summer and a heater/light bulb for the winter. The Pan D'oro made it happen. I turned again to the internet and with the help of MC@Farine  I found a design for a proofer that Steve@Bread cetera posted @Fresh Loaf, and I took it a step further. I went looking for a thermostat for reptiles.... and ended up at Craigs list with the perfect solution... a Ranco ETC microprocessor  temperature controller thermostat that plugs into the heating unit or refrigeration system. It really takes the prize and i got it for a good price from a home brewer who started making babies and his wife made him stop making suds. After fooling around with it...I have found... I can control  the internal temperature within a degree of where i want it to be......the only thing I would consider changing is the probe. I have found that i can insert it into the dough and and get spot on readings...a new tip to the probe would make it perfect! The rest of the proofer is make shift.  I got a sheet of insulation board from Home Depot and cut it to fit my in my pantry. The heat source is a 75 w light bulb. I also have an indoor outdoor thermometer i had laying around that sound an alarm if it goes past a set temperature...just as a fail safe.My original intention was to get a small refrigerator or wine vault so I could bake all summer without a problem. The project has been put on hold...I have been busy packing my house to rent for an extended trip to France in the very near future. Iam going to try to find a way to take it with me! If you have any question comment below...or drop my a note...


Cheers...



                                                                   


 


 


 


 

Subscribe to RSS - Make shift proofing box...